With Infoblox you’re almost doing everything through the WebUI on the Infoblox Grid Master. At least the daily business such as adding/changing/deleting/moving/whatever DNS, DHCP, and IPAM stuff. Even troubleshooting is almost done through this HTTPS-based GUI. However, some circumstances require the use of the CLI on an Infoblox appliance/VM, called “Remote Console Access” aka SSH. Here are the most common troubleshooting CLI commands for Infoblox DDI. Samples on how to use the IPMI/LOM features round things up:
Tag Archives: Factory Reset
Juniper ScreenOS Initial Cleanup Config
I still like the Juniper ScreenOS firewalls such as the SSG 5 or the SSG 140. However, they are End of Everything (EoE) and not used at the customers anymore. But they still do their job in basic networking (static/dynamic routing such as OSPF & BGP, IPv6, NAT), basic firewalling (access policies), and IPsec VPN. Hence I am using a couple of SSGs in my lab when playing with routing protocols and so on.
After a factory reset of those firewalls there are some default settings such as zones at a few interfaces and default IP addresses. Therefore I put the following commands together in order to cleanup the default config to have only IP addresses and default routes which is a good starting point for lab configurations. Let’s go: