It’s really great that the FortiGate firewalls have a DHCPv6 server implemented. With this mandatory service, IPv6-only networks can be deployed directly behind a FortiGate because the stateless DHCPv6 server provides the DNS server addresses. (This is unlike Palo Alto or Cisco which have no DHCPv6 server implemented.)
UPDATE: In the meantime Fortinet has implemented the RDNSS and DNSSL options as well. Great. Hence you don’t need DHCPv6 at all anymore to run an IPv6-only network. I updated my listings below as well.
However, the configuration on the FortiGate is really bad because nothing of the IPv6 features can be set via the GUI. (And this is called a Next-Generation Firewall? Not only the features count, but also the usability!) Everything must be done through the CLI which is sometimes hard to remember. Therefore I am publishing this memo of the appropriate CLI configuration commands.
Continue reading Basic IPv6 Configuration on a FortiGate Firewall
When explaining IPv6 I am always showing a few Wireshark screenshots to give a feeling on how IPv6 looks like. Basically, the stateless autoconfiguration feature (SLAAC), DHCPv6, Neighbor Discovery, and a simple ping should be seen/understood by any network administrator before using the new protocol.
Therefore I captured the basic IPv6 autoconfiguration with a Knoppix Linux behind a Telekom Speedport router (German ISP, dual-stack) and publish this capture file here. I am using this capture to explain the basic IPv6 features.
Continue reading Basic IPv6 Messages: Wireshark Capture
Since IPv6 gets more and more important, I am using it by default on all my test firewalls, which of course support IPv6. However, when comparing the different functions and administration capabilities, they vary significantly.
Here comes my short evaluation of the IPv6 functions on the following four firewalls: Cisco ASA, Fortinet FortiGate, Juniper SSG, and Palo Alto.
Continue reading Firewall IPv6 Capabilities: Cisco, Forti, Juniper, Palo